Aurora V6-214 3.5L VIN H SFI (2001)
Installation Procedure
1. Apply a liberal amount of clean engine oil GM P/N 12345501 or equivalent to the roller (2), lash adjuster and valve tip areas (1) of the camshaft
followers.
Important: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If
the followers are being reused you must put them back in their original location.
2. Place the camshaft followers in position on the valve tip and lifter. The rounded head end of the follower goes on the lash adjuster while the flat
end goes on the valve tip.
3. Clean the camshaft journals and carriers with a clean, lint-free cloth.
Important: Use the J 43032 in order to make sure that the crankshaft is in the TDC position.
