Aurora V6-214 3.5L VIN H SFI (2001)
Important: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If
the followers are being reused you must put them back in their original location.
2. Place the camshaft followers in position on the valve tip and lifter. The rounded head end of the follower goes on the lash adjuster while the flat
end goes on the valve tip.
3. Clean the camshaft journals and carriers with a clean, lint-free cloth.
Important: Use the J 43032 in order to make sure that the crankshaft is in the TDC position.
4. Select the proper camshaft for the particular installation location. The left cylinder head camshafts (1,2) are longer than those for the right cylinder
head (3,4). However, both sets of camshafts share the same placement of identification rings. The ring placement is defined as follows:
4.1.
The identification ring for the intake camshafts (1,3) is located between the first and second sets of lobes.
4.2.
The identification ring for the exhaust camshafts (2,4) is located between the second and third sets of lobes.