Aurora V6-214 3.5L VIN H SFI (2001)
13. If necessary, disassemble the camshaft cover.
14. Clean and inspect the camshaft cover.
Installation Procedure
1. If necessary, assemble the camshaft cover.
2. Wipe the right cylinder head sealing surface with a clean, lint-free cloth.
3. Inspect the right camshaft cover seals (perimeter and spark plug) for damage. Check to make sure the perimeter seal is not pulled from its
groove.Replace the seals if they are damaged or pulled from the groove.
4. Place the right camshaft cover in position on the cylinder head.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the right camshaft cover retaining bolts.
^
Tighten the right camshaft cover retaining bolts to 9 Nm (80 inch lbs.).
6. Push the spark plug boots onto the ignition coil assembly.
7. Install the right ignition coil assembly to the right camshaft cover.
