Aurora V6-214 3.5L VIN H SFI (2001)
13. Connect the fuel pressure regulator vacuum tube (1) to the regulator (2) and the throttle body (3).
14. Connect the A/C vacuum hose to the intake manifold.
15. Install the engine wiring harness and channel.
16. Install the engine wiring harness channel bolts to the camshaft covers.
^
Tighten the engine wiring harness channel bolts to 10 Nm (89 inch lbs.).
17. Connect the surge tank inlet pipe retainer to the fuel injector rail.
18. Connect the engine wiring harness connectors to the following components:
^
Throttle position (TP) sensor
^
Idle air control (IAC) valve
^
EVAP canister purge solenoid
^
Manifold absolute pressure (MAP) sensor
19. Connect the fuel injector wiring harness connectors.
20. Connect the throttle body coolant hoses to the throttle body.
21. Connect the accelerator cable to the throttle body and accelerator cable bracket.
22. Connect the cruise control cable to the throttle body.
