Aurora V6-214 3.5L VIN H SFI (2001)
IMPORTANT: The bolt retaining the condenser to the radiator end tank is a special length and should be the ONLY bolt used upon reinstallation.
The use of a longer bolt will damage the radiator end tank.
11. Remove the two condenser to radiator mounting bolts.
12. Separate the condenser from the radiator by lifting out of the lower mounting tabs.
13. Remove the two A/C condenser seals.
14. Lift the condenser up and remove from the vehicle.
INSTALLATION PROCEDURE
1. Add the proper amount of refrigerant oil to the condenser. Refer to Refrigerant System Capacities.
2. Place the condenser into the vehicle.
3. Install the condenser into the lower radiator mounting tabs.
IMPORTANT: The bolt retaining the condenser to the radiator end tank is a special length and should be the ONLY bolt used upon reinstallation.
The use of a longer bolt will damage the radiator end tank.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the condenser mounting bolts.
Tighten
Tighten the connections to 6 N.m (53 lb in).
