Aurora V6-214 3.5L VIN H SFI (2001)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor (HO2S) 2 Replacement
REMOVAL PROCEDURE
CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.
1. Raise the vehicle.
2. Remove the oxygen sensor wiring harness heat shield. Refer to Oxygen Sensor Wiring Harness Heat Shield Replacement in Exhaust System.
3. Disconnect the HO2S electrical connector (1).
4. Remove the electrical connector from the mounting hole.
5. Remove the HO2S from the exhaust pipe using the J 39194-B
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Ensure that the correct replacement HO2S is used. The engine HO2S 1 and the post-converter HO2S 2 are both 6.6-watt Denso
sensors. Due to differences in pigtail length, the sensors use different connectors and are not interchangeable.
1. Install the HO2S in the rear exhaust pipe using the J 39194-B
Tighten
Tighten the HO2S to 41 N.m (30 lb ft).
2. Install the electrical connector into the mounting hole.
