Aurora V6-214 3.5L VIN H SFI (2001)
Cigar Lighter Relay
The scan tool displays On/off. Display indicates the commanded state of the cigar lighter relay.
Clutch Voltage
The scan tool displays Low or Normal. Low is displayed when the battery voltage is low, such that clutch slippage is possible.
Commanded Blower
The scan tool displays 0 to 100%.
Component Serial # 8-11
The scan tool displays an alphanumeric number. Display indicates digits 8 to 11 of the component serial number of the control module.
Component Serial #12
The scan tool displays an alphanumeric number. Display indicates digit 12 of the component serial number of the control module.
Component Serial #13-16
The scan tool displays an alphanumeric number. Display indicates digits 13 to 16 of the component serial number of the control module.
Component Serial #17-18
The scan tool displays an alphanumeric number. Display indicates digits 17 to 18 of the component serial number of the control module.
Component Serial Number
The scan tool displays an alphanumeric number. Display indicates the serial number of the module.
Control Head (Desired)
The scan tool displays A/C On or A/C Off. A/C On is displayed when the IPM is requesting A/C system operation.
Control Power
The scan tool displays On/Off. Display indicates the state of control power.
Coolant Temperature
The scan tool range is -39° C to +140° C (-38° F to +284° F). The PCM applies 5 volts to the ECT sensor circuit. The sensor is a thermistor that
changes internal resistance as temperature changes. When the sensor is cold (internal resistance high), the PCM monitors a high signal voltage and
interprets the voltage as a cold engine. As the sensor warms (internal resistance decreases), the voltage signal decreases and the PCM interprets the lower
voltage as a warm engine.
CTD State
The scan tool displays Alarm/Armed/Arm Pending/Ignition/Standby, indicating the state of the content theft deterrent system (CTD).
Daytime Running Lamp
The scan tool displays On/Off. Display indicates the commanded state of the daytime running lamp relay.
Driver Door Jamb Sw.
The scan tool displays On/Off. Display indicates the state of the drivers door jamb switch. On indicates the door is open and Off indicates the door is
closed.
Driver/Pass. Heated Seat Sw.
The scan tool displays ON/OFF. This parameter indicate the mode of operation that has been selected.
Evaporator Temp Status
The scan tool displays OK or Cold. Cold is displayed when evaporator temperature drops below 5°C (41 °F).
Evaporator Temp.
The scan tool displays -40° C to 215° C (40 to 420° F). The output of the A/C low side thermistor.
Filter Position Value
The scan tool displays 0-255 counts. This parameter is not used and the scan tool will always display 0.
