Aurora V6-214 3.5L VIN H SFI (2001)
1. Install the EGR outlet pipe (3) between the intake manifold and the coolant crossover assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the lower flange mounting bolt (2) into the coolant crossover assembly.
Tighten
Tighten the bolt to 24 N.m (18 lb ft).
3. Install the upper flange mounting bolts (1) into the intake manifold.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
4. Keeping the injector sight shield as level as possible, place the rear (1) of the shield under the mounting bracket (6).
5. Align and press the injector sight shield (4) onto the mounting studs (5).
6. Install the mounting nuts (2) onto the mounting studs (5)
Tighten
Tighten the nuts to 3 N.m (27 lb in).