Aurora V6-214 3.5L VIN H SFI (2001)
^
Inspect the CKP sensor and replace the sensor if any of the following conditions are present:
-
The bracket is damaged.
-
The bottom of the brass housing exhibits any damage.
-
Never install a sensor that has been dropped.
^
Lubricate the O-ring on the sensor with Amojell or clean engine oil prior to installing the sensor.
^
Check all the connectors for any damaged terminals.
1. Lubricate the CKP sensor O-ring.
2. Install and fully seat the CKP sensor (2) into the engine block.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the CKP sensor mounting bolt (1).
Tighten
Tighten the mounting bolt to 9 N.m (80 lb in).
4. Ensure that the CKP sensor mounting flange is contacting the engine block.
5. Connect the electrical connector to the CKP sensor (2).
6. Re-install or tighten the starter motor (1) as necessary. Refer to Starter Motor Replacement (LX5) or Starter Motor Replacement (L47) in Starting
and Charging.
7. Reconnect the negative battery cable.
8. Lower the vehicle.
9. The CKP System Variation Learn Procedure must be performed after replacing the CKP sensor. Even if the original sensor is reinstalled the Learn
Procedure must be performed. See: Testing and Inspection/Programming and Relearning
