Aurora V6-214 3.5L VIN H SFI (2001)
Left Rear Door Jamb Sw.
The scan tool displays On/Off. Display indicates the state of the left rear door jamb switch. On indicates the door is open and Off indicates the door is
closed.
Left Solar
The scan tool displays 0 to 50 counts. The solar load output of the LH sunload sensor and ambient light sensor.
Left Solar Sensor
The scan tool displays 0 to 50 counts. The status of the sensor signal circuit is monitored. A 0 count indicates a short to ground, 255 counts indicates an
open circuit.
Left Temp Dr. Actual
The scan tool displays 0 to 255 counts (0 to 5 volts). The signal output from the feedback pot on the actuator.
Left Temp Dr. Commanded
The scan tool displays 0 to 255 counts (0 to 5 volts). The desired position of the actuator.
Leveling Sensor Feed
The scan tool displays volts, indicating the position of the ALC level sensor.
Lights On With Wipers
The scan tool displays On/Off-display indicates the state of the wiper/washer system.
Load Reduction Active
The scan tool displays Yes/No. Display indicates the state of the IPM load reduction command.
Load Shed Lvl. 1 Heated Seats
The scan tool displays Enabled/Disabled. When enabled the RIM cycles the heated seats at an 50% duty cycle.
Load Shed Lvl. 1 R. Defog
The scan tool displays Enabled/Disabled. When enabled the RIM cycles the rear defog at an 80% duty cycle.
Load Shed Lvl. 2 Heated Seats
The scan tool displays Enabled/Disabled. When enabled the RIM turns off the heated seats.
Load Shed Lvl. 2 R. Defog
The scan tool displays Enabled/Disabled. When enabled the RIM turns off the rear defog.
Low Beam Output
The scan tool displays On/Off. Display indicates the commanded state of the low beam relay.
Max Air Inlet Dr Pos
The scan tool displays 0 to 255 counts (0 to 5 volts). The minimum travel range when driven to the stop during Recalibrate All Motors command.
Max Left Temp Dr Pos
The scan tool displays 0 to 255 counts (0 to 5 volts). The minimum travel range when driven to the stop during Recalibrate All Motors command.
Max Right Temp Dr Position
The scan tool displays 0 to 255 counts (0 to 5 volts). The maximum travel range when driven to the stop during Recalibrate All Motors command.
Max. Htr./Def./A/C Dr.
The scan tool displays 0 to 255 counts (0 to 5 volts). The minimum travel range when driven to the stop during Recalibrate All Motors command.
Min Air Inlet Dr Pos
The scan tool displays 0 to 255 counts (0 to 5 volts). The maximum travel range when driven to the stop during Recalibrate All Motors command.
Min Left Temp Dr Position
The scan tool displays 0 to 255 counts (0 to 5 volts). The minimum travel range when driven to the stop during Recalibrate All Motors command.
Min Right Temp Dr Position
The scan tool displays 0 to 255 counts (0 to 5 volts). The minimum travel range when driven to the stop during Recalibrate All Motors command.