Aurora V6-214 3.5L VIN H SFI (2001)
Body Control Module: Scan Tool Testing and Procedures
A/C Clutch (Actual)
The scan tool displays On or Off. On is displayed when the PCM has energized the A/C clutch relay.
A/C Clutch (Desired)
The scan tool displays On or Off. On is displayed when the IPM is requesting A/C system operation and the DIM has determined that none of the system
performance limits are exceeded.
A/C Orifice Relay
The scan tool displays Active or Inactive. Active is displayed when the orifice tube relay is energized by the DIM increasing the orifice diameter and
lowering A/C high side pressure.
A/C Pressure
The scan tool displays 0 to 4000 kpa (0 to 580 psi). The output of the A/C pressure sensor provided by the PCM over the Class 2 communication link.
A/C Requested
The scan tool displays Yes or No. The message sent Out on class 2 to the DIM when A/C is requested.
Accum Fault-Compressor
The scan tool displays Active/Inactive. Display indicates a defined period of time the compressor is active with out an exhaust cycle.
Accum Fault-Exhaust
The scan tool displays Active/Inactive. Display indicates a defined period of time that the exhaust is active with out a compressor cycle.
Air Inlet Dr Actual
The scan tool displays 0 to 255 counts (0 to 5 volts). The signal output from the feedback pot on the actuator.
Air Inlet Dr Commanded
The scan tool displays 0 to 255 counts (0 to 5 volts). The desired position of the actuator.
ALC Compressor Active
The scan tool displays Yes if the ALC compressor is operating or No if the is not operating.
ALC Exhaust Solenoid Active
The scan tool displays Yes/No. Display indicates the state of the ALC exhaust solenoid relay.
Ambient Light Sensor
The scan tool displays volts. Display indicates the ambient light sensor input signal, 0.09-4.75 volts is the normal operating range.
Battery Low-Compressor
The scan tool displays Active/Inactive. When the RIM detects battery voltage below 11 volts the RIM disables the ALC compressor.
Battery Reconnect
The scan tool displays On/Off. When the RIM senses a battery reconnect the scan tool will display On.
Battery Save Active In Past
The scan tool displays Yes/No. Scan too displays Yes if the DIM has enter the battery save mode.
Battery Voltage
The scan tool displays 0-30 Volts. The voltage measured between the module's battery positive voltage circuit and ground circuit.
Brake To Shift Relay
The scan tool displays On/Off. Display indicates the state of the stoplamp/auto trans shift lock control relay.
Calibration ID
The scan tool displays a 4 digit alphanumeric number. This number designates the modules calibrations.
