Aurora V6-214 3.5L VIN H SFI (2001)
Ignition Control Module: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the electrical connector from the ignition control module (ICM).
2. Remove the cover (4) from the ignition coils (3).
3. Remove the screws (1) retaining the PCM.
4. Remove the ignition control module (2).
INSTALLATION PROCEDURE
IMPORTANT: When servicing the ignition system components, use the following recommended procedures:
^
Do not re-install any component that has visible signs of damage.
^
Clean all the mounting surfaces before re-installing any components.