Aurora V6-214 3.5L VIN H SFI (2001)
5. Route the IP module wiring harness (2) in place to secure IP module yellow connector clip to IP (3).
6. Install the IP upper trim pad.
7. Clip the IP module yellow connector (2) to IP bracket (3).
8. Install the IP module yellow connector (2) to the vehicle harness yellow connector (1).
9. Install the Connector Position Assurance (CPA) (4) to the IF module connector (2).
10. Install passenger (right) insulator panel.
IMPORTANT: After replacing a deployed or undeployed dual stage inflator module, correct disposal is required. A deployed dual stage inflator
module must be energized to ensure that both stages are no longer active. Refer to Inflator Module Handling and Scrapping for proper disposal.
11. Enable the SIR system.
Inflatable Restraint Steering Wheel Module Replacement
TOOLS REQUIRED
J 44298 Driver Air Bag Removal Tool
REMOVAL PROCEDURE
CAUTION:
^
Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.
^
A deployed dual stage inflator module will look the same whether one or both stages were used, always assume a deployed dual stage
inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury. Refer to
SIR Inflator Module Handling and Storage Caution.
