Aurora V6-214 3.5L VIN H SFI (2001)
6. Clear a space on the ground about 1.85 m (6 ft) in diameter for deployment of the inflator module or deployment fixture. If possible, use a paved,
outdoor location free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
IMPORTANT: Dual stage air bags deployments are only used in steering wheel and IP inflator modules, if the vehicle is equipped. If stage 1 was
use to deploy a dual stage inflator module, stage 2 may still be active. If disposal of a deployed or undeployed dual stage module is required both
deployment loops must be energized to deploy the air bag.
8. If you have a steering wheel inflator module, place the inflator module in the center of the space.
9. If you have an IP inflator module, refer to the following instructions:
^
Place the J 394018 SIR deployment fixture (2) in the center of the cleared area.
^
Fill the deployment fixture with water or sand.
^
Using the proper nuts and bolts, mount the IP module (1) to the deployment fixture (2), with the vinyl trim facing up
^
Tighten all fasteners that hold the IP module (1) to the deployment fixture (2).
