Aurora V6-214 3.5L VIN H SFI (2001)
14. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
IMPORTANT: On the steering wheel dual stage inflator module both connectors must be attached to the deployment harness adapter. This will
ensure that both stage 1 and stage 2 of the deployment loops are energized, regardless of the deployment state.
15. Connect the inflator module to the adapter (2) on the SIR deployment harness (1).
16. Place a 12 V minimum/2 A minimum power source (i.e., vehicle battery) near the shorted end of the harness.
IMPORTANT:
^
The rapid expansion of gas involved with deploying an inflator module is very loud. Notify all the people in the immediate area that you intend to
deploy the inflator module.
^
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of the inflator module
due to the force of the rapid expansion of gas inside the inflator module.
^
If you are deploying a dual stage inflator module with stage 1 already deployed, the fixture may not move and the noise may have been reduced.
17. Clear the area of people.
