Aurora V8-4.0L VIN C (1996)
Cruise Control Servo Cable: Adjustments
1. Turn engine off and remove servo cable retaining clips.
2. With ignition On, using tech 1 scan tool, select misc. test (F4).
3. Select ISC (F3), then ISC motor retract. Press (F3) to fully retract ISC motor.
4. Throttle lever must not be in contact with ISC plunger.
5. Connect cruise control cable to hole in servo blade that leaves minimum cable slack.
6. Insert servo retaining clip.
7. Using Tech 1 scan tool, exit ISC motor retract and perform idle learn procedure.