Aurora V8-4.0L VIN C (1996)
18.
Connect the power steering outlet hose (1) to the power steering pump assembly.
19.
Tighten the nut (2) securing the power steering outlet hose to the upper generator frame attachment stud.
Tighten
Tighten the upper generator frame attachment nut to 21 Nm (15 lb ft).
20.
Raise and suitably support the vehicle.
21.
Tighten the nut (3) securing the power steering outlet hose to the lower generator frame attachment stud.
Tighten
Tighten the lower generator frame attachment nut to 21 Nm (15 lb ft).
22.
Connect the power steering outlet hose to the power steering gear assembly.
Tighten
Tighten the power steering gear outlet hose to the steering gear to 27 Nm (20 lb ft).
23.
On 1995-1998 vehicles, position the two retaining clips (4) on the top surface of the front engine frame crossmember over the existing holes and
fasten with two 10 mm bolt/screws.
Tighten
Tighten the retaining clip bolt/screws to 6 Nm (53 lb in).
Important:
Using a 90 degree angle head drill with a short drill bit is recommended.
24.
On 1999 vehicles:
24.1. On the top surface of the front engine frame crossmember, drill two 5 mm (0.2 in) holes using the attached retaining clips as templates.
24.2. Position the retaining clips so that the metal part of the hose does not contact the cradle.
