Aurora V8-4.0L VIN C (1996)
2.
Electrical connector(s).
3.
Left lower I/P insulator.
Starter Enable Relay
Remove or Disconnect
1.
Left lower I/P insulator, (2) screws, (1) light bulb.
2.
Electrical connector(s).
Slide starter enable relay from bracket.
Install or Connect
1.
Slide starter enable relay onto bracket.
2.
Electrical connector(s).
3.
Left lower I/P insulator.
Lamp Control Module
Remove or Disconnect
1.
Left lower I/P insulator, (2) screws, (1) light bulb.
2.
Electrical connector(s).
3.
Lamp control module from multi-use bracket. Press down on center tab of mounting bracket and slide module downward until mounting rails
disengage.
Install or Connect
1.
Lamp control module to multi-use bracket.
^
Align mounting rails on module with mounting bracket rails.
^
Slide module forward into place until locking tab engages.
2.
Electrical connector(s).
3.
Left lower I/P insulator.