Bravada V6-262 4.3L VIN W CPI (1994)
7.
Obtain the J 35800-A (2). Make sure the valve at the bottom of the canister (3) is closed.
8.
Remove the canister top and add 24 ml (0.8 fl. oz.) Top Engine Cleaner, GM P/N 1050002 (Canada P/N 992872), to the canister.
9.
Fill the remainder of the canister with regular unleaded gasoline and install the canister top.
10.
Suspend J 35800-A from a convenient location under the vehicle.
11.
Connect the hose from J 35800-A to the service port on the J 44466-1.
12.
Open the valve (3) at the bottom of J 35800-A.
13.
Connect a "shop air" source to the fitting at the top of J 35800-A and adjust the regulator (1) to 75 psi.
14.
Lower the vehicle to a convenient height and start the vehicle. It may be necessary to re-adjust the J 35800-A pressure regulator to maintain 75 psi.
15.
Let the vehicle run at idle until the canister is empty and the vehicle stalls.
16.
Turn OFF the vehicle ignition switch.
17.
Raise the vehicle.
18.
Remove the shop air supply from J 35800-A.
19.
Depressurize J 35800-A.
20.
Disconnect J 35800-A from J 44466-1.
21.
Remove J 44466-1 and J 44466-2 from the vehicle fuel lines.
22.
Re-connect the vehicle fuel lines.
23.
Lower the vehicle.
24.
Add one (1) ounce of Port Fuel Injector Cleaner, GM P/N 12345104 (Canada GM P/N 10953467), to the vehicle's fuel tank for each gallon of
gasoline estimated to be in the tank. Instruct the customer to add the remainder of the bottle of Port Fuel Injector Cleaner to the vehicle's fuel tank
at the next fill-up.
25.
Tighten the fuel tank filler cap.
26.
Start the engine and check for fuel leaks.
27.
Clear any Powertrain DTC codes as required.
28.
Advise the customer to change brands of fuel.
