Bravada V6-262 4.3L VIN Z (1991)
7.
Disconnect the power window release actuator cable, if equipped.
8.
Remove the window latch assembly from the endgate and discard.
9.
Preassemble the lock rods to the new endgate window latch assembly (P/N 20367780 currently available from GMSPO) and install. DO NOT
force the lock rods into position. The lock rods should line up with the attaching hole or stud on the window latch lever.
Note:
The temporary look rod positioning fastener must be in place for this procedure (Figure 2, Item 4). If the rods do not align with the attaching hole or
stud, adjust the rod(s) by turning to either lengthen or shorten as required.
10.
Remove and discard the temporary lock rod positioning fastener.
11.
Reconnect the power window release actuator cable, if equipped.
12.
Check for proper endgate operation. If necessary, readjust the lock rods. (Step 10).
13.
Reattach the endgate inner panel reinforcement.
14.
Adjust the latch assembly as described in steps 1-3 of the "Adjusting Procedure".
15.
Reinstall the inner trim panel.
16.
Reconnect the negative battery cable.
