Bravada V6-262 4.3L VIN Z (1991)
2.
Use J 35856 to depress and hold the valve stem on the combination valve during the bleeding operation.
3.
Install the bleeder adapter.
4.
Bleed each wheel in the following sequence.
-
Right rear
-
Left rear
-
Right front
-
Left front
5.
Connect the hose from the bleeder to the adapter at the master cylinder.
6.
Open the tank valve.
7.
Attach a hose to a brake bleeder screw.
8.
Immerse the opposite end of the hose into a container partially filled with clean brake fluid.
9.
Open the bleeder screw at least 3/4 of a turn and allow the fluid to flow until no air is seen in the fluid.
10.
Close the bleeder screw.
11.
Repeat steps seven (7) through ten (10) at all the wheels.
12.
Check the brake pedal for "sponginess". Repeat the entire bleeding procedure if this condition is found.
13.
Remove J 35856.
14.
Disconnect the line from the bleeder adapter.
15.
Remove the bleeder adapter.
16.
Fill the master cylinder to the proper level with brake fluid.
