oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Engine - Cold Knock|Page 2992 > < PROM - Powertrain Control Module Reprogramming
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine - Cold Knock

NUMBER: 92-T-178

CORP.REF.NO: 376105

DATE: September 1993

SECTION: 6A, 6E3, V6

SUBJECT:
COLD ENGINE KNOCK - INSTALL CHECK VALVE OIL FILTER/REPLACE PROM

MODELS/YEARS:
1991-92 BRAVADA

CONDITION:
Some 1991 and early 1992 Bravadas with the 4.3L (VIN Z, LB4) engine have been reported to exhibit "cold knock" on start up. "Cold knock" usually
occurs after the vehicle has been completely warmed, then parked for 8 or more hours in ambient temperatures of 2~C/35~ F or less. "Cold knock" can
be separated into three distinct categories.

A.

Short Duration - Harsh deep metallic knock that usually lasts from 1 to 10 seconds. Generally classified as a bearing or rod knock.

B.

Valve Train - Light clatter, tick or click that may last up to 1 minute.

C.

Piston Slap - Metallic knock that occurs only under load. Piston slap may last as long as 5 minutes.

CORRECTION - CATEGORY A: Short Duration Knock 
^

For 1992 LB4 4.3L VIN Z ONLY:
Install PF52 oil filter. Install a revised PROM that reduces the engine spark advance after the engine is started. The reduction in spark lowers the
cylinder pressure and eliminates the knock. The revised PROM will NOT eliminate a piston slap (Category C) or valve train noise (Category B)
concern. The base cold knock PROMs contain the previously released calibration update for torque converter clutch (TCC) lock-up (see Dealer
Technical Bulletin 92-T-34). If a vehicle has had a detonation fix PROM installed previously, select the combined detonation and cold knock fix
PROM for the application.

Note:
Use of a detonation fix PROM in a non-detonating vehicle may result in degraded driveability.

GMSPO will be temporarily stocking four (4) PROMs for each light duty 1992 model year LB4 application.

^

Base

^

Detonation Fix

^

Cold Knock Fix

^

Combination Cold Knock and Detonation Fix

The detonation fix (detonation fix only) PROMs will not be restocked by SPO when the current supply is exhausted. If a detonation fix PROM is
required after the existing stock is exhausted, the combination cold knock and detonation PROM is to be used. SPAC (Special Parts Assistance Center)
will have information available on each PROM. Select the PROM from the table. Old broadcast code (OLD B/C code) information has been supplied to
help determine if a detonation fix PROM has been installed previously. If the Old B/C code can be found in the first table, a detonation fix has not been
installed.

PROMs are currently available from GMSPO.

1992 LB4 VIN Z
For vehicles with "cold knock" only

For vehicles with "cold knock" having previously installed detonation field fix PROM

Engine - Cold Knock|Page 2992 > < PROM - Powertrain Control Module Reprogramming