Bravada V6-262 4.3L VIN Z (1991)
4.
Remove drive axle cotter pin, retainer, nut, and washer (Figure 2).
5.
Loosen (do not remove at this time) six bolts securing inboard C/V joint drive flange to output shaft companion flange (Figure 3).
Figure 4
6.
Remove brake line support bracket from upper control arm to allow extra travel of knuckle (Figure 4).
7.
Remove cotter pin and nut from the outer tie rod.
Figure 5
8.
Separate the outer tie rod ball stud from the steering knuckie using J24319-01 (Figure 5).
Notice:
Do not attempt to disengage the joint by driving a wedge-type tool between the joint and the knuckle because the seal may be damaged.
9.
Push linkage to opposite side of the vehicle and secure older tie rod up and out of the way. This will provide the needed clearance to remove the
drive axle.
