Bravada 2WD L6-4.2L VIN S (2002)
8. Position the inboard retainer (1) to the roof panel.
NOTE: Refer to Fastener Notice in Service Precautions.
9. Install the inboard retaining screw.
Tighten
Tighten the screw to 1.2 N.m (10 lb in).
10. With the sunshade parallel to the windshield, index the pivot arm tab to the roof panel slot.
11. Apply and maintain upward pressure to the pivot arm while rotating the sunshade parallel to the side window. The sunshade arm should appear
flush with the bezel.
12. Rotate and clip the sunshade to the inboard retainer.
13. Ensure the pivot arm retaining tabs are fully seated to the roof panel.
14. Install the front assist handle to the roof panel.
15. Install the windshield garnish molding.
16. Install the center pillar trim panel.
17. Return the bucket seat to an upright position.
