Bravada 2WD L6-4.2L VIN S (2002)
2.
Partially remove the mirror glass from the mirror housing.
3.
Disconnect the two mirror heater wires (2) from the mirror glass while holding down the terminals on the glass. The terminals may pull off the
mirror glass it they are not held in place. Unclip the electrochromic mirror wire harness connector (3) from the back of the mirror glass and
disconnect it. Refer to the illustration above.
4.
Remove the mirror glass from the mirror assembly.
5.
Remove the three mirror actuator retaining screws (4) using a size Ti 0 TORX® driver. Refer to the illustration above for locations.
6.
Remove the actuator assembly from the mirror housing.
7.
Disconnect the two electrical connectors from the mirror actuator.
8.
Remove the mirror actuator from the mirror assembly.
9.
Connect the two electrical connectors to the new mirror actuator.
10.
Install the actuator into the mirror housing using the three T10 TORX(R) head retaining screws.
