Bravada 2WD L6-4.2L VIN S (2002)
1. Install the weatherstrip/run channel assembly to the door.
2. Install the quarter glass into the window opening by pressing the window channel (4) rearward until the retaining clip is fully installed.
3. Press the weatherstrip (1) into the window frame opening.
4. Position the tabs on the weatherstrip into the slots on the door.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the weatherstrip/run channel retaining bolt.
Tighten
Tighten the bolt to 10 N.m (88 lb in).
6. Install the window glass into the run channel, slide up to the closed position, tape the window to the door frame.
7. Install the window regulator.
8. Install the water deflector.
9. Install the outer window belt sealing strip.
10. Install the inner window belt sealing strip.
11. Install the trim panel.
