Bravada 2WD L6-4.2L VIN S (2002)
1. Install the weatherstrip/run channel assembly to the door.
2. Install the quarter glass into the window opening by pressing the window channel (4) rearward until the retaining clip is fully installed.
3. Press the weatherstrip (1) into the window frame opening.
4. Position the tabs on the weatherstrip into the slots on the door.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the weatherstrip/run channel retaining bolt.
Tighten
Tighten the bolt to 10 N.m (88 lb in).
6. Install the window glass into the run channel, slide up to the closed position, tape the window to the door frame.
7. Install the window regulator.
8. Install the water deflector.
9. Install the outer window belt sealing strip.
10. Install the inner window belt sealing strip.
11. Install the trim panel.
Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer, Envoy, Bravada)
Window Weatherstrip Run Channel Assembly Replacement - Rear (Trailblazer, Envoy, Bravada)
Removal Procedure
1. Remove the trim panel.
2. Remove the inner window belt sealing strip.
3. Remove the outer window belt sealing strip.
4. Remove the water deflector.
5. Remove the window.
6. Remove the bolt that retains the weatherstrip run channel to the door.
7. Pull the weatherstrip/run channel from the window frame opening.
8. carefully release the double sided tape attaching the molding to the outside of the door.
9. Carefully twist the weatherstrip run channel and pull up at the top of the door frame.
Important: The quarter glass and weatherstrip/run channel is not serviceable and should be replaced only as an assembly.
