Bravada 2WD L6-4.2L VIN S (2002)
CAUTION: Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an
explosion.
5. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
6. Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
7. Command the fuel pump ON with a scan tool.
8. Close the bleed valve on the fuel pressure gage.
9. Inspect for fuel leaks.
REMOVAL PROCEDURE
1. Place the fuel pressure gage bleed hose into an approved container and open the bleed valve to bleed fuel system pressure.
2. Place a shop towel under the fuel pressure gage adaptor fitting to catch any remaining fuel spillage.
3. Remove the J 34730-1A from the pressure gage fitting.
4. Drain any fuel remaining in the fuel pressure gage into an approved container.
5. Install the cap on the fuel pressure connection.
6. Inspect for leaks using the following procedure:
6.1.
Turn ON the ignition, with the engine OFF for 2 seconds.
6.2.
Turn OFF the ignition for 10 seconds.
6.3.
Turn ON the ignition, with the engine OFF.
6.4.
Inspect for fuel leaks.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the fuel tank shield if applicable.
