Bravada 2WD L6-4.2L VIN S (2002)
Housing Assembly HVAC: Service and Repair
HVAC Module Assembly Replacement - Auxiliary
REMOVAL PROCEDURE
1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
4. Remove the nuts (3) from rear A/C line block fittings.
IMPORTANT: Cap or tape the open A/C refrigerant lines immediately.
5. Remove the A/C line block fittings and discard the O-ring seals.
6. Remove the nuts from the heater hoses block fittings.
7. Remove the heater hoses block fittings from the HVAC module-auxiliary.
8. Remove the nuts from the HVAC module studs.
9. Lower the vehicle.
10. Remove the right side rear quarter trim.
