Bravada 2WD L6-4.2L VIN S (2002)
Brake Light Switch: Service and Repair
Stop Lamp Switch Replacement
Removal Procedure
1. Remove the pushrod retainer (3) from the brake pedal pin (4).
2. Remove the stop lamp switch (1) and the pushrod (2) from the brake pedal pin (4).
3. Disconnect the electrical connector and remove the stoplamp switch (1).
Installation Procedure
1. Install the electrical connector on the stop lamp switch (1).
2. Position the stop lamp switch (1) on the pushrod (2) and install on the brake pedal pin.
3. Install the pushrod retainer (3) to the brake pedal pin (4). The retainer will snap into place.
