Bravada 2WD L6-4.2L VIN S (2002)
22.
Remove the screws retaining the IP bezel to the IP and remove the bezel (TrailBlazer only).
23.
Remove the screws retaining the carpet panel to the lower IP center control panel pedestal (except TrailBlazer).
24.
Remove the screws that retain the IP center trim panel to the dash, loosen the trim panel, disconnect the wiring and remove the trim panel from the
vehicle (except TrailBlazer).
25.
Remove the radio retaining screws, pull the radio forward and disconnect all connectors.
26.
Unwrap/cut the white tape on the new speaker wiring harness to spread out the wiring harness.
27.
With both of the green connectors and the first breakout of four wires in hand, insert the new wiring harness from under the IP up to the radio area
of the IP, where the radio is normally positioned.
28.
Through the left side speaker opening, slide a piece of mechanics wire to the area of the radio.
29.
Attach the green connector with the two blue wires to the mechanics wire and gently pull the wiring pigtail into the speaker opening.
30.
Disconnect the mechanics wire from the speaker wires, connect the speaker wires to the speaker and fasten the speaker to the IP.
31.
Repeat the last three steps for the right speaker.
32.
Remove the CPA from the radio connector, remove the wires shown below from the radio connector and replace them with the wires from the new
wiring harness.
^
Remove wire in cavity B9 and insert the Brown wire.
^
Remove wire in cavity B8 and insert the Brown/White wire.
^
Remove wire in cavity A10 and insert the Black wire.
^
Remove wire in cavity A11 and insert the Blue wire.
^
Reinstall the CPAs to the radio connector.
^
Cut the terminal from the wires you just removed from the connector.
33.
Position the radio to the IP opening, reconnect the connectors and install the retainers.
34.
Gently pull the carpet from under the right side of the shifter/console support, route the new wiring harness along and below the right side of the
shifter/console support plate, place the new harness under the carpet to the area of the rear audio control, and reposition the carpeting.
35.
Remove the CPA from the rear audio control connector and remove four wires from the Rear Audio Control in-line harness connector and replace
them with the wires from the new harness as listed below.
^
Remove wire in cavity B3 and insert the Brown wire.
^
Remove wire in cavity A8 and insert the Brown/White wire.
^
Remove wire in cavity A9 and insert the Blue wire.
^
Remove wire in cavity A1 and insert the Black wire.
^
Replace the CPA.
^
Cut off all removed terminals and wires of the original harness, as close to the taped portion of the harness as possible.
36.
While lifting the carpet in the rear door area, slide the rear electrical center through the cutout in the carpet. Continue lifting the carpet enough to
gain access to the three in-line connectors located inboard of the rear electrical center.
37.
Locate the 8-way connector with the purple CPA. Separate the connector and remove the CPA from the female side of the connector.
38.
Route the new harness under the carpet from the rear of the console to the 8-way connector.
39.
Remove the four wires from the 8-way harness connector and replace them with the wires from the new harness. DO NOT UNTWIST THE
