Bravada 2WD L6-4.2L VIN S (2002)
^
Remove wire in cavity B10 and insert the Dark Green wire.
^
Remove wire in Cavity B11 and insert the Light Green wire.
^
Reinstall the CPAs to the radio connector.
^
Cut the terminals and the wires of the original harness you removed from the connector.
25.
Position the radio to the IP opening, reconnect the connectors and install the retainers.
26.
Gently pull the carpet from under the right side of the shifter/console support, route the new wiring harness along and below the right side of the
shifter/console support plate, place the new harness under the carpet and reposition the carpeting
27.
While lifting the carpet in the rear door area, slide the rear electrical center through the cutout in the carpet. Continue lifting the carpet enough to
gain access to the three in-line connectors located inboard of the rear electrical center.
28.
Locate the 8-way connector with the purple CPA. Separate the connector. Remove the CPA from the female side of the connector.
29.
Route the new harness under the carpet from the rear of the console to the 8-way connector.
30.
Remove the eight wires from the 8-way in line harness connector and replace them with the wires from the new harness.
Important:
These wires are twisted pairs and they must be positioned properly in the connector, or audio system performance will be affected.
^
Insert the Gray wire into cavity A.
^
Insert the Tan wire into cavity B.
^
Insert the Dark Green wire into cavity C.
^
Insert the Light Green wire into cavity D.
^
Insert the Yellow wire into cavity E.
^
Insert the Brown wire into cavity F.
^
Insert the Light Blue wire into cavity G.
^
Insert the Dark Blue wire into cavity H.
31.
Reinstall the CPA, reconnect the 8-way connector, and reattach it to its retaining clip.
32.
Cut the wires and terminals from the wires you have removed from the 8-way connector as close to the taped portion of the original wiring harness
as possible.
33.
Reposition the rear electrical center through the carpet and reposition the carpet.
34.
Reinstall the rear electrical center bracket and tighten.
Tighten
Tighten the rear electrical center retaining nuts to 10 N.m (89 lb in).
35.
Reconnect the negative battery cable.
Tighten
Tighten the battery ground (negative) terminal bolt to 17 N.m (13 lb ft).
36.
Insert the ignition key and turn to the RUN position Verify radio operation. If all is in working order, proceed to the next step. Otherwise, check
your work.
37.
Turn the key OFF. Remove the key.
