Bravada 2WD L6-4.2L VIN S (2002)
58.
Install the IP upper trim panel and windshield pillar moldings.
59.
Reinstall the SIR fuse #18 in the underhood electrical center and close the hood.
60.
Connect the Tech 2(R) and clear codes.
Bose(R) Premium Sound Without Rear Audio Controls
These vehicles use wiring harness P/N 15164931, which you will modify slightly by cutting some unused wires.
1.
Remove the key from the lock cylinder.
2.
Remove the SIR fuse # 18 from the underhood electrical center.
3.
Remove the windshield pillar trim from both windshield pillars.
4.
Remove the upper IP closeout panel.
5.
Remove both front upper IP panel speakers.
6.
Disconnect the wires from both speakers. Cut the green connectors from the speaker wires as far up under the IP as possible.
7.
Remove the retainers that secure the driver's seat assembly to the floor of the vehicle.
8.
Disconnect the wires from the driver's seat and remove the driver's seat.
9.
Disconnect the negative battery cable.
10.
Remove the left rear seat cushion and the back rest assemblies.
11.
Remove the jack handle tool support assembly.
12.
Loosen the rear electrical center from the floor of the vehicle.
13.
Separate the rear electrical center from its mounting bracket.
14.
Remove the left side front and rear door opening carpet retainers and the left side first lock pillar trim.
15.
Remove the six retaining screws from the console compartment bin and remove the bin.
16.
Remove the shift lever handle and boot assembly.
17.
Remove the screws that retain the console to the floor of the vehicle.
18.
Set the parking brake as firmly as possible, depress the Auto Trans Shift Lock Control solenoid plunger and shift the transmission shift lever to the
L1 position.
19.
Lift the console, disconnect the console wiring and remove the console from the vehicle.
20.
Remove the left side closeout/insulator panel (TrailBlazer only).
21.
Remove the left side knee bolster (TrailBlazer only).
22.
Remove the screws retaining the IP bezel to the IP, and remove the bezel (TrailBlazer only).
23.
Remove the screws retaining the carpet panel to the lower IP center control panel pedestal (except TrailBlazer).
24.
Remove the screws that retain the IP center trim panel to the IP, loosen the trim panel, disconnect the wiring and remove the trim panel from the
vehicle (except TrailBlazer).
25.
Remove the radio retaining screws, pull the radio forward and disconnect all connectors.
26.
Unwrap/cut the white tape on the new speaker wiring harness to spread out the wiring harness.
Important:
