Bravada 2WD L6-4.2L VIN S (2002)
43.
Insert the ignition key and turn to the RUN position. Verify radio operation. If all is in working order, proceed to the next step. Otherwise, check
your work.
44.
Turn the key OFF. Remove the key.
45.
Reinstall the rear seat backrest and seat cushion assemblies.
Tighten
Tighten all of the rear seat back rest and seat cushion retaining nuts to 45 N.m (33 lb ft).
46.
Reinstall the jack handle base (tool carrier).
Tighten
Tighten the nuts to 7 N.m (62 lb in).
47.
Reinstall the rear electrical center cover.
48.
Reconnect the electrical connectors to the IP trim plate, position the IP trim plate and install the retaining screws.
49.
Reinstall the knee bolster (TrailBlazer).
50.
Reinstall the closeout/insulator panel (TrailBlazer).
51.
Reinstall the center IP carpet lower trim panel and install the screws (except TrailBlazer).
52.
Reinstall the console to the vehicle and install the retainers.
53.
Reinstall the shift boot and handle assembly.
54.
Reinstall the console bin and retainers.
55.
Reinstall the first lock pillar trim and carpet retainers to both door openings.
56.
Position the driver's seat assembly in the vehicle, connect the wiring and install the retainers.
Tighten
Tighten the retaining nuts to 45 N.m (33 lb ft).
57.
Install the IP upper trim panel and windshield pillar moldings.
58.
Reinstall the SIR fuse # 18 in the underhood electrical center and close the hood.
59.
Connect the Tech 2(R) and clear codes.
Non Bose(R) Radios With Rear Audio Controls
These vehicles use wiring harness P/N 15164933.
1.
Remove the key from the lock cylinder.
2.
Remove the SIR fuse # 18 from the underhood electrical center.
3.
Remove the retainers that secure the driver's seat assembly to the floor of the vehicle.
4.
Disconnect the wires from the driver's seat and remove the driver's seat.
5.
Disconnect the negative battery cable.
6.
Remove the left rear seat cushion and the back rest assemblies.
7.
Remove the jack handle tool support assembly.
