Bravada 2WD L6-4.2L VIN S (2002)
38.
Reinstall the rear seat backrest and seat cushion assemblies.
Tighten
Tighten all of the rear seat back rest and seat cushion retaining nuts to 45 N.m (33 lb ft).
39.
Reinstall the jack handle base (tool carrier).
Tighten
Tighten the nuts to 7 N.m (62 lb in).
40.
Reinstall the rear electrical center cover.
41.
Reconnect the electrical connectors to the IP trim plate, position the IP trim plate, and install the retainers.
42.
Reinstall the knee bolster (TrailBlazer).
43.
Reinstall the left side closeout/insulator panel (TrailBlazer).
44.
Reinstall the center IP carpet lower trim panel and install the screws (except TrailBlazer).
45.
Reinstall the console to the vehicle and install the retainers.
46.
Reinstall the shift boot and handle assembly.
47.
Reinstall the console bin and retainers.
48.
Reinstall the first lock pillar trim and carpet retainers to both door openin9s.
49.
Position the drivers seat assembly in the vehicle. Connect the wiring and install the retainers.
Tighten
Tighten the retaining nuts to 45 N.m (33 lb ft).
50.
Reinstall the SIR fuse # 18 in the underhood electrical center and close the hood.
51.
Connect the Tech 2(R) and clear codes.
