Bravada 2WD L6-4.2L VIN S (2002)
32.
Reposition the rear electrical center through the carpet and reposition the carpet.
33.
Reinstall the rear electrical center bracket and tighten.
Tighten
Tighten the rear electrical center retaining nuts to 10 N.m (89 lb in).
34.
Reconnect the negative battery cable.
Tighten
Tighten the battery ground (negative) terminal bolt to 17 N.m (13 lb ft).
35.
Insert the ignition key and turn to the RUN position. Verify radio operation. If all is in order, proceed to the next step. Otherwise, check your
work.
36.
Turn the key OFF. Remove the key.
37.
Reinstall the rear seat backrest and seat cushion assemblies.
Tighten
Tighten all of the rear seat back rest and seat cushion retaining nuts to 45 N.m (33 lb ft).
38.
Reinstall the jack handle base (tool carrier).
Tighten
Tighten the nuts to 7 N.m (62 lb in).
39.
Reinstall the rear electrical center cover.
40.
Reconnect the electrical connectors to the IP trim plate, position the IP trim plate and install the attaching screws.
41.
Reinstall the knee bolster (TrailBlazer).
42.
Reinstall the left side closeout/insulator panel (TrailBlazer).
43.
Reinstall the center IP carpet lower trim panel and install the screws (except TrailBlazer).
44.
Reinstall the console to the vehicle and install the retainers.
45.
Reinstall the shift boot and handle assembly.
46.
Reinstall the console bin and retainers.
47.
Reinstall the first lock pillar trim and carpet retainers to both door openings.
48.
Position the driver's seat assembly in the vehicle. Connect the wiring and install the retainers.
Tighten
Tighten the retaining nuts to 45 N.m (33 lb ft).
49.
Reinstall the SIR fuse # 18 in the underhood rear electrical center and close the hood.
50.
Connect the Tech 2(R) and clear codes.
Non Bose(R) Radios Without Rear Audio Controls
These vehicles use wiring harness P/N 15164934.
1.
Remove the key from the lock cylinder.
