Bravada 2WD L6-4.2L VIN S (2002)
11.
Connect the mirror heater and electrochromic mirror glass connectors to the mirror. Use a new mirror glass if the original one was damaged or
broken during the removal procedure. Clip the electrochromic harness connector to the back of the mirror glass and route the mirror wires as
shown in the illustration above.
12.
Install the mirror glass into the mirror housing by pushing the mirror glass onto the mirror actuator, ensuring that all the retaining tabs are fully
seated.
13.
Repeat this replacement procedure if the mirror actuator is being replaced on the right side of the vehicle.
14.
Verify proper operation of both mirror assemblies.
Parts Information
Parts are expected to be available 4-2-2002 from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.