Bravada 2WD L6-4.2L VIN S (2002)
10. Connect the negative battery cable.
11. If installing a replacement BCM, program the BCM. Refer to Body Control Module (BCM) programming/RPO Configuration. See: Testing and
Inspection/Programming and Relearning
Body Wiring Harness Extension Replacement - BCM
REMOVAL PROCEDURE
IMPORTANT:
^
The ignition switch should be in the OFF position when connecting or disconnecting the connectors to the body control module (BCM).
^
Always disconnect the 40-way body wiring extension FIRST, the 32-way tan connector SECOND and the 24-way gray electrical connector LAST.
^
Always connect the 24-way gray electrical connector FIRST, the 32-way tan connector SECOND and the 40-way body wiring extension LAST.
^
The BCM can set DTCs with the ignition switch in the OFF position. The BCM has battery run down protection for the courtesy lamp circuit. The
BCM battery run down protection cannot detect shorts on inputs or other circuits which the BCM does not control. Use the scan tool in order to
activate the POWER DOWN NOW mode. Use the POWER DOWN NOW mode in order to check for current draws on circuits that are not
controlled by the BCM, or controlled by the battery run down protection system.
^
Do not touch the exposed electrical contacts of the body wiring extension.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. If replacing the BCM on a Chevrolet Trailblazer EXT or GMC Envoy XL, remove the left second row seat.
3. If replacing the BCM on a Chevrolet Trailblazer, GMC Envoy or Oldsmobile Bravada, position the left hand second seat to a cargo position.
4. Remove the rear electrical center cover.
5. Press down and hold the locking tab (1).
6. Disengage the sliding latch retaining the BCM to the rear electrical center.
Slide the latch inboard until fully extended, approximately 40 mm (1.6 in).
