Bravada 2WD L6-4.2L VIN S (2002)
3.
If both the driver and passenger front safety belts lock when performing the inspection, no further action is required. If any of the seat belts did not
lock up, refer to the Seat Belt Retractor Replacement Procedure, and replace the applicable retractor.
Seat Belt Retractor Replacement
Important
The service procedure contained in this recall is different from the service procedure found in the appropriate service manual. As a result, the
labor time allowance has been revised to correspond with this new service procedure. In the near future the service manual and labor time
guide will be updated with this new information.
Important
For U.S. and Canada: All replaced seat belt retractors are to be held until a return request is received from the GM Warranty Parts Center
(WPC).
Important
Do not remove the seat from the vehicle when performing the following procedure.
1.
Remove the SIR fuse.
2.
Disconnect the side impact air bag electrical connector located under the seat.
3.
If equipped, remove the lumbar knob and/or seat back recliner screw and handle.
4.
Remove the screws attaching the seat switch bezel and reposition the bezel.
5.
Remove the outer trim panel attaching screws and remove the panel from the side of the seat cushion.