Bravada 2WD L6-4.2L VIN S (2002)
13.
Carefully remove the seat back cover from behind the trim edge of side impact air bag module.
Important
When separating the seat cover hook and loop retaining strip in the next step, do not pull the adhesive-backed strip from the pad.
14.
Using a side-to-side motion, carefully lift off the seat back cover, partially separating the seat back cover from the foam pad.
15.
From the bottom of the seat back, place your hand up the front side of the seat back cover and release the hook and loop fasteners that attach the
seat back cover to the foam pad.
16.
Starting at the bottom of the seat back, remove the seat back cover by pulling the cover upwards. The bottom of the cover should be turning inside
out as the cover rolls upwards.
Important
Do not remove the three hog rings that attach the cover to the foam pad.
17.
Continue pulling the seat back cover upwards until the top of the seat belt retractor is accessible.
18.
If equipped, disconnect the seat back heating element electrical connector.
19.
Remove the two head restraint retainers from the top of the seat back.
20.
Reposition the cover and pad as necessary.
