Bravada 2WD L6-4.2L VIN S (2002)
connector/leads on the body harness by splicing in the service pigtail, P/N 15306403, using the procedure listed below.
Passenger Door
1.
Inspect the passenger door harness connector (9 wires) and terminals (inline to body harness).
^
If there is no evidence of corrosion, verify that the three empty cavities of the plastic connector are properly blocked. If two cavities are open,
clean the connector using an electrical contact cleaner and fill the two open/unblocked cavities using RTV.
^
If the terminals or connector show signs of corrosion, replace the door harness. Refer to the Front Door Wiring Harness Replacement
procedure in the Doors sub-section of the Service Manual. Ensure the replacement door harness has unused cavities blocked.
2.
Inspect the body harness connector (9 wires) and terminals (inline to passenger door harness).
^
If there is no evidence of corrosion, verify that the three empty cavities of the plastic connector are properly blocked. If two cavities are open,
clean the connector using an electrical contact cleaner and fill the two open/unblocked cavities using RTV.
^
If there is evidence of corrosion, replace the mating connector/leads on the body harness by splicing in the service pigtail, P/N 88953131,
using the procedure listed below.
Service Pigtail Procedure
1.
Remove the closeout/insulator panel.
2.
Remove the door sill plate.
3.
Pull back the carpet for access.
4.
Remove the driver foot rest pad.
5.
Release the harness to body clips.
6.
Pull the existing body harness through the door jam and into the body.
7.
Cut the existing harness and splice in the service pigtail. Refer to Wiring Repairs in the Wiring Systems sub-section of the Service Manual.
8.
Feed the harness through the body and into the door jam.
9.
Install the harness to body clips.
10.
Install the driver foot rest pad.
11.
Install the carpet in place.
12.
Install the door sill plate.
13.
Install the closeout/insulator panel.
