Bravada 2WD L6-4.2L VIN S (2002)
With the new harness stretched out on a work surface, you will find two multi-terminal breakouts midway down the harness. You will need to
trim these wire breakouts from the harness by cutting the four wires below at both locations as close to the taped portion of the harness as
possible.
^
The Brown wire
^
The Brown/White wire
^
The Black wire
^
The Blue wire
What you will end up with is a new harness with two green connectors on one end and four terminals on the other end.
27.
Position the new radio speaker wiring harness to the vehicle. The small green connectors go to the upper IP speakers.
28.
With the green connectors in hand, insert the new wiring harness from under the IP up to the radio area of the IP where the radio is normally
positioned.
29.
Through the left side speaker opening, slide a piece of mechanics wire to the area of the radio.
30.
Attach the green connector with the two blue wires to the mechanics wire and gently pull the wiring pigtail into the speaker opening.
31.
Disconnect the mechanics wire from the speaker wires. Connect the speaker wires to the speaker and fasten the speaker to the IP.
32.
Repeat the last three steps for the right speaker.
33.
Position the radio to the IP opening, reconnect the connectors and install the retainers.
34.
Gently pull the carpet from under the right side of the shifter/console support, route the new wiring harness along and below the right side of the
shifter/console support plate, place the new harness under the carpet and reposition the carpeting.
35.
While lifting the carpet in the rear door area, slide the rear electrical center through the cutout in the carpet. Continue lifting the carpet enough to
gain access to the three in-line connectors located inboard of the rear electrical center.
36.
Locate the 8-way connector with the purple CPA. Separate the connector and remove the CPA from the female side of the connector.
37.
Route the new harness under the carpet from the rear of the console to the 8-way connector.
38.
Remove the four wires from the 8-way harness connector and replace them with the wires from the new harness. DO NOT UNTWIST THE
WIRES if they are twisted.
^
Remove wire in cavity A and insert the Light Blue wire.
^
Remove wire in cavity B and insert the Dark Blue wire.
^
Remove wire in cavity C and insert the Dark Green wire.
^
Remove wire in cavity D and insert the Orange wire.
39.
Reinstall the CPA, reconnect the 8-way connector, and reattach it to its retaining clip.
40.
Reposition the rear electrical center through the carpet and reposition the carpet.
41.
Reinstall the rear electrical center bracket and tighten the retainers.
Tighten
Tighten the rear electrical center retaining nuts to 10 N.m (89 lb in).
42.
Reconnect the negative battery cable.
Tighten
Tighten the battery ground (negative) terminal bolt to 17 N.m (13 lb ft).
