Bravada 2WD L6-4.2L VIN S (2002)
8.
Loosen the rear electrical center from the floor of the vehicle.
9.
Separate the rear electrical center from its mounting bracket.
10.
Remove the left side front and rear door opening carpet retainers and the left side first lock pillar trim.
11.
Remove the six retaining screws from the console compartment bin and remove the bin.
12.
Remove shift lever handle and boot assembly.
13.
Remove the screws that retain the console to floor of the vehicle.
14.
Set the park brake as firmly as possible, depress Auto Trans Shift Lock Control solenoid plunger and pull the shift lever to the L1 position.
15.
Lift the console, disconnect the console wiring and remove the console from the vehicle.
16.
Remove the left side closeout/insulator panel (TrailBlazer only).
17.
Remove the left side knee bolster (Trail Blazer only).
18.
Remove the screws retaining the IP bezel to the IP, and remove the bezel (TrailBlazer only).
19.
Remove the screws retaining the carpet panel to the lower IP center control panel pedestal (Except TrailBlazer).
20.
Remove the screws that retain the IP center trim panel to the IP, loosen the trim panel, disconnect the wiring and remove the trim panel from the
vehicle (except TrailBlazer).
21.
Remove the radio retaining screws, pull the radio forward arid disconnect all connectors.
22.
Unwrap/cut the white tape on the new speaker wiring harness to spread out the wiring harness.
23.
The radio end of the harness has the foam anti-rattle wrap around it. Feed the radio end of the new harness from under the IP to the area of the
radio.
24.
Remove the CPA from the radio connector, remove the wires in the cavities listed below from the radio connector and replace them with the wires
from the new wiring harness.
Important:
These wires are twisted pairs and they must be positioned properly in the connector, or audio system performance will be affected.
^
Remove wire in cavity A8 and insert the Tan wire.
^
Remove wire in cavity A9 and insert the Gray wire.
^
Remove wire in cavity A10 and insert the Black wire.
^
Remove wire in cavity A11 and insert the Dark Blue wire.
^
Remove wire in cavity B8 and insert the Brown wire.
^
Remove wire in cavity B9 and insert the Brown/White wire.
^
Remove wire in cavity B10 and insert the Dark Green wire.
^
Remove wire in Cavity B11 and insert the Light Green wire.
^
Reinstall the CPAs to the radio connector.
^
Cut the terminals and the wires of the original harness you removed from the connector.
25.
Position the radio in the IP opening, reconnect the connectors and install the retainers.
26.
Gently pull the carpet from under the right side of the shifter/console support, route the new wiring harness along and below the right side of the
shifter/console support plate, place it under the carpet to the area of the rear audio control and reposition the carpeting.
