Bravada 2WD L6-4.2L VIN S (2002)
27.
Remove the CPA from the rear audio control connector and remove the eight wires from the designated cavities of the rear audio control in-line
harness connector and replace them with the wires from the new harness as listed below.
Important:
These wires are twisted pairs and they must be positioned properly in the connector or audio system performance will be affected. Also, this
wiring harness has two Dark Blue and two Brown wires. It may be necessary to cut a small portion of the electrical tape wrap to determine
which wires are paired.
^
Pair One
-
Remove wire in cavity B3 and insert the Brown/White wire.
-
Remove wire in cavity A8 and insert the Brown wire.
^
Pair Two
-
Remove wire in cavity A9 and insert the Dark Blue wire.
-
Remove wire in cavity A1 and insert the Black wire.
^
Pair Three
-
Remove wire in cavity B1 and insert the Brown wire.
-
Remove wire in cavity B5 and insert the Yellow wire.
^
Pair Four
-
Remove wire in cavity B6 and insert the Light Blue wire.
-
Remove wire in cavity B2 and insert the Dark Blue wire.
^
Replace the CPA.
^
Cut off all removed terminals and wires as close to the taped portion of the original harness as possible.
28.
Lift the carpet in the left rear door area, and slide the rear electrical center through the cutout in the carpet. Continue lifting the carpet enough to
gain access to the three in-line connectors located inboard of the rear electrical center.
29.
Locate the 8-way connector with the purple CPA. Separate the connector and remove the CPA from the female side of the connector.
30.
Route the new harness under the carpet from the rear of the console to the 8-way connector.
31.
Remove the eight wires from the 8-way inline harness connector and replace them with the wires from the new harness.
Important:
These wires are twisted pairs and they must be positioned properly in the connector or audio system performance will be affected.
^
Remove wire in cavity A and insert the Gray wire.
^
Remove wire in cavity B and insert the Tan wire.
^
Remove wire in cavity C and insert the Dark Green wire.
^
Remove wire in cavity D and insert the Light Green wire.
^
Remove wire in cavity E and insert the Yellow wire.
^
Remove wire in cavity F and insert the Brown wire.
^
Remove wire in cavity G and insert the Light Blue wire.
^
Remove wire in cavity H and insert the Dark Blue wire.
^
Reinstall the CPA, reconnect the 8-way connector and reattach it to its retaining clip.
