Bravada 2WD L6-4.2L VIN S (2002)
^
Approved, you will receive a check from General Motors.
^
Denied, you will receive a letter from General Motors with the reason(s) for the denial, or
^
Incomplete, you will receive a letter from General Motors identifying the documentation that is needed to complete the claim and offered the
opportunity to resubmit the claim when the missing documentation is available.
Please follow the instructions on the Claim Form provided to file a claim for reimbursement. If you have questions about this reimbursement procedure,
please call the toll-free telephone number provided at the bottom of the form. If you need assistance with any other concern, please contact the
appropriate Customer Assistance Center at the number shown. The Customer Assistance Center hours of operation are from 8:00 AM - 11:00 PM eastern
standard time Monday through Friday.
Disclaimer
Service Procedure
The following service procedure provides instructions for installing a jumper harness in series between the compressor for the electronic
controlled air suspension (ECAS) and the vehicle wiring harness underneath the vehicle.
1.
Raise the vehicle on a suitable hoist and support as necessary.
Important
When disconnecting the electrical connector in the next step, the grey colored terminal cover inside the harness connector may remain in the
connector on the ECAS compressor. If this occurs, the new jumper harness cannot be connected to the compressor until the grey cover is
removed.
2.
Locate and disconnect the eight-way electrical connector (2) from the ECAS compressor (1).
3.
Connect one end of the new jumper harness to the connector on the ECAS compressor.
4.
Connect the other end of the jumper harness to the connector on the vehicle harness.
5.
Secure the new jumper harness to the original vehicle wiring harness using the plastic tie strap.
