Bravada 2WD L6-4.2L VIN S (2002)
2.
Remove the SIR fuse # 18 from the underhood electrical center.
3.
Remove the retainers that secure the driver's seat assembly to the floor of the vehicle.
4.
Disconnect the wires from the driver's seat and remove the driver's seat.
5.
Disconnect the negative battery cable.
6.
Remove the left rear seat cushion and the back rest assemblies.
7.
Remove the jack handle tool support assembly.
8.
Loosen the rear electrical center from the floor of the vehicle.
9.
Separate the rear electrical center from its mounting bracket.
10.
Remove the left side front and rear door opening carpet retainers and the left side first lock pillar trim.
11.
Remove the six retaining screws from the console compartment bin and remove the bin.
12.
Remove the shift lever handle and boot assembly.
13.
Remove the screws that retain the console to floor of the vehicle.
14.
Set the parking brake as firmly as possible, depress the Auto Trans Shift Lock Control solenoid plunger and shift the transmission shift lever to the
L1 position.
15.
Lift the console, disconnect the wiring and remove the console from the vehicle.
16.
Remove the left side closeout/insulator panel (TrailBlazer only).
17.
Remove the left side knee bolster (TrailBlazer only).
18.
Remove the screws retaining the IP bezel to the IP, and remove the bezel (TrailBlazer only).
19.
Remove the screws retaining the carpet panel to the lower IP center control panel pedestal (except TrailBlazer).
20.
Remove the screws that retain the IP center trim panel to the IP, loosen the trim panel, disconnect the wiring and remove the trim panel from the
vehicle (except TrailBlazer).
21.
Remove the radio retaining screws, pull the radio forward and disconnect all connectors.
22.
Unwrap/cut the white tape on the new speaker wiring harness to spread out the wiring harness.
23.
The radio end of the harness has the foam anti-rattle wrap around it. Feed the radio end of the new harness from under the IP to the area of the
radio.
24.
Remove the CPA from the radio connector, remove the wires in the cavities listed below from the radio connector and replace them with the wires
from the new wiring harness.
Important:
These wires are twisted pairs and they must be positioned properly in the connector, or audio system performance will be affected.
^
Remove wire in cavity A8 and insert the Tan wire.
^
Remove wire in cavity A9 and insert the Gray wire.
^
Remove wire in cavity A10 and insert the Light Blue wire.
^
Remove wire in cavity A11 and insert the Dark Blue wire.
^
Remove wire in cavity B8 and insert the Brown wire.
^
Remove wire in cavity B9 and insert the Yellow wire.
