Bravada 2WD L6-4.2L VIN S (2002)
1.
Attach the J 43485 to the J 35555 or equivalent.
2.
Place the J 43485 on or in the pump reservoir filler neck.
3.
Apply a vacuum of 68 kPa (20 in Hg) maximum.
4.
Wait 5 minutes.
5.
Remove the J 43485 and the J 35555.
6.
Verify the fluid level.
7.
Reinstall the pump reservoir cap.
8.
Start the engine. Allow the engine to idle.
9.
Turn off the engine.
10.
Verify the fluid level.
11.
Start the engine. Allow the engine to idle.
Notice:
Do not hold the wheel against the stops while bleeding the system. Holding the steering wheel against wneel stops wil cause high system pressure,
overheating, and damage to the pump and/or gear.
12.
Turn the steering wheel 180 - 360 degrees in both directions five times.
13.
Switch the ignition OFF.
14.
Verify the fluid level.
15.
Repeat steps 1-14.
16.
Reinstall the pump reservoir cap.
17.
Clean any spilled fluid.
18.
Remove the fender covers.
19.
Close the hood.
20.
Lower the vehicle.
21.
Test the vehicle to verify that the steering functions normally and is free from noise.
