Bravada 2WD L6-4.2L VIN S (2002)
Tools Required
*
J 24402-A Glass Sealant Remover (Cold Knife)
*
J 39032 Stationary Glass Removal Tool
*
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
*
Isopropyl Alcohol or Equivalent
*
Cartridge-type Caulking Gun
*
Commercial-type Utility Knife
*
Razor Blade Scraper
*
Suction Cups
*
Plastic Paddle
Removal Procedure
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces
and the interior trim.
1. Open the hood.
Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
2. Cover and protect the following parts from broken glass.
*
Upper dash pad.
*
Defroster outlets and A/C outlets.
*
Seats and carpeting.
3. Remove the fixed antenna mast if equipped.
4. Remove the windshield wiper arms.
5. Remove the cowl air inlet grille panel.
6. Remove the push pins (2) from the front door sealing weatherstrips (1) located at the base of the pillar.
7. Reposition the front door sealing weatherstrips (1) in order to access to the side reveal molding screws.
It is not necessary to remove the front door sealing weatherstrip completely from the vehicle.
