Bravada 2WD V8-5.3L VIN P (2004)
3. Remove the communication interface module.
4. Remove the navigation control processor bracket.
5. Remove the seat back, left and right side.
6. Remove the front bucket seats.
7. Remove the front door sill plates.
8. Remove the rear door sill plates.
9. Remove the lift gate door sill plate.
10. Remove the center pillar trim panels.
11. Remove the lower rear quarter trim panels.
12. Remove the tool kit carrier.
13. Remove the bussed electrical center junction block from the bussed electrical center base, and the bussed electrical center base from the floor
panel studs.
14. Remove the child restraint tether anchors.
15. Remove the bussed electrical center base and communication interface module electrical connectors through the pass through holes in the carpet.
16. Remove the floor console to the floor console carrier.
17. Remove the four nuts retaining the rear of the floor console bracket to the floor weld studs.
18. Raise the rear portion of the floor console bracket and remove the carpet from underneath the console bracket.
19. Remove the carpet from the vehicle.
Installation Procedure
Caution: In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material
size as the original installation. Always return the carpet to the original location.
1. Position the carpet to the floor panel.