Bravada 2WD V8-5.3L VIN P (2004)
9. Release the five screws that retain the rear quarter trim panel to the body.
10. Remove the rear quarter trim panel from the vehicle.
INSTALLATION PROCEDURE
1. Install the auxiliary power outlet to the trim panel.
2. Position the trim panel to the vehicle.
3. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
4. Index the locating tabs on the trim panel to the holes in the body.
5. Connect the wiring harness connector to the auxiliary power outlet.
6. Install the five screws that the retain the rear quarter trim panel to the body.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.5 N.m (22 lb in).
7. Install the seat belt lower anchor.
Tighten the anchor bolt to 70 N.m (52 lb ft).
8. Install the left rear door sill panel.
9. Install the lift gate sill plate.
10. Install the left body side window forward garnish molding.
11. Install the left body side window rear garnish molding.
12. Return the third row seats to the upright position.
